How to Prevent and Resolve Lens Fogging on AKASO 360 Camera

AKASO 360 cameras are designed to capture immersive moments in various environments. However, under certain conditions, you may notice fog or condensation forming on the inside of the camera lenses. This article explains why this happens and provides practical steps to clear the fog and prevent it from recurring.

Why Does Lens Fogging Occur?

Fogging inside the lenses is primarily caused by condensation of moisture within the camera body. This is more common in action cameras and 360 cameras that are not hermetically sealed for deep waterproof use.

Here are the key reasons:

1. Weather-Resistant, Not Fully Waterproof
   The AKASO 360 camera is designed to be splash-resistant and protected against rain or snow, but it is not completely airtight. This means some humid air can enter the body over time.
2. Temperature Changes
   When the camera is used after being in a cool or humid environment (e.g., moving from an air-conditioned room to a warm outdoor setting), the internal components warm up during operation. Moisture inside evaporates, rises, and then condenses on the cooler inner surface of the lenses.
3. Trapped Moisture
   If the camera has been exposed to high humidity or stored in a damp place, moisture can accumulate inside. Since the camera is not fully sealed, this moisture may condense on the lenses when the internal temperature rises during use.

Note: This phenomenon is not unique to AKASO cameras. Many 360 and action cameras with similar weather-resistant designs may experience internal fogging under humid conditions.

How to Remove Lens Fogging

If you notice fog or droplets inside the lenses, follow the steps below to safely remove the moisture.

Recommended Method (Based on Industry Practice):

1. Power On the Camera
   Turn on your AKASO 360 camera and let it run for a few minutes. This allows the internal components to generate mild heat.
2. Open the Battery Compartment
   Carefully open the battery compartment door while the camera is still powered on. This creates an opening for the moist air to escape.
3. Allow Moisture to Evaporate
   Keep the camera running with the battery door open for 10–20 minutes in a dry, warm environment (not in direct sunlight or extreme heat). The gentle warmth from the camera will help evaporate the moisture, which can then exit through the open compartment.
4. Check the Lenses
   After the recommended time, check if the fog has cleared. If condensation remains, repeat the process or leave the camera (with battery door open) in a dry place for a longer period.
5. Reassemble and Use
   Once the lenses are clear, close the battery compartment securely before using the camera again.

Tips to Prevent Future Fogging

• Store your camera in a dry, cool place with low humidity when not in use.
• Avoid moving the camera suddenly from a cold to a warm environment. If possible, let it acclimatize gradually.
• Keep the camera away from water submersion, as it is designed for weather resistance, not underwater use without a housing.
• Use silica gel packs in your camera storage case to absorb excess moisture.
• If you frequently use the camera in humid conditions, consider placing it in a sealed bag with a desiccant when storing.

Questions? Click to email us: cs@akasotech.com