You can use the remote to control the camera to take photos, take videos, and stop videos.
-
Please confirm the remote battery is in full condition;
-
The remote can be used up to 10 meters away in optimal conditions.
-
The remote is splashproof only, not waterproof.
-
For EK7000, one remote can control some cameras at the same time.
How to use it?
To start recording: To record Video, verify the camera is in Video mode, Press the Grey Video Button. The video indicator of the remote control lights up red. The camera will emit one beep and the camera light will flash while recording.
To stop recording: Press the Grey Video Button again. The video indicator of the remote control lights up red. The camera will emit one beep and the camera light will stop flashing while recording.
To take a photo: To capture a photo, verify the camera is in Photo mode. Press the Red Photo Button. The photo indicator of the remote control lights up red. The camera will emit a camera shutter sound. To take a Burst Photo series: To capture a Burst Photo series, verify the camera is in Burst Photo mode. Press the Red Photo Button. The photo indicator of the remote control lights up red. The camera will emit a camera shutter sound.
To take Time-Lapse: To capture a Time-Lapse series, verify the Continuous Lapse is ON and the camera is in Time-Lapse Mode. Press the Red Photo Button. The photo indicator of the remote control lights up red. The camera initiates a countdown and emits a camera shutter sound each time a photo is taken.
Comments
3 comments
In fact it does not explain HOW to connect the Akaso 7 to the remote control.
I finally got the correct instructions from someone in customer service. Amazing that they cannot seem to get this in their FAQs.
Press the power button to turn on the remote control. When the red and blue lights flash, the remote control is waiting to connect to the camera.
Then you need to pair the camera and remote. Turn on the camera, ensure that the remote is enabled in settings. Please press the remote Set and Record buttons at the same time till the red and blue lights turn on and stay on for one second. When the remote is connected to the camera, its screen will display the current camera status information, the two lights will also turn off.
That's it, that's all. Worked great for me.
The remote is not working at all. No light glows when I press either of the buttons. I changed the battery too, but it's not working.
Please sign in to leave a comment.